Guide & connection service — not a plumbing firm, and it performs no plumbing workEaling, London W5 & W13No telephone number is published for this service — requests go through the form
Emergency Plumber Ealing
The Isolation Register — first isolate, then decide

Emergency 02 · Boiler breakdown

No heating, no hot water: what you can check, and what you must not open.

Many boiler call-outs end with a repressurised system, a reset condensate pipe, or a timer that was never on. Those checks are yours to do. Everything inside the case is not.

The Gas Safe line, stated plainly. Work on a gas boiler, gas pipework, flues and gas appliances must be carried out by an engineer on the Gas Safe Register, qualified for that category of work — check the back of their ID card, which lists what they may work on. A general plumber who is not Gas Safe registered must not do gas work, and this site will not describe a connection for gas work as a plumbing job. If you smell gas, or suspect carbon monoxide, turn off the appliance if safe, ventilate, leave, and call the National Gas Emergency Service on 0800 111 999. Carbon monoxide alarms are a legal requirement in relevant rooms in rented homes and a sensible one everywhere.

Checks that are safe to do yourself

  • Power and controls: is the boiler switched on, the programmer calling for heat, the room thermostat turned up, and the fuse spur untripped?
  • Pressure: on a sealed system the gauge should usually read about 1 to 1.5 bar when cold. Below about 0.5 bar many boilers lock out. The filling loop and the maker’s instructions explain repressurising; if pressure falls again within days, there is a leak or a failed expansion vessel — that needs an engineer.
  • Error code: note the exact code and look it up in the manual. Quote it in any request: it changes who should attend and what parts they bring.
  • Frozen condensate pipe: in a cold snap, the white plastic pipe running outside can freeze and the boiler locks out. Warm water poured over the pipe (not boiling water) and a reset often clears it.
  • Radiators cold at the top: trapped air; bleed with a radiator key with the heating off, then recheck pressure.

What the engineer does next

Diagnosis follows the fault code, combustion and safety checks, then the failed component: commonly a diverter valve, pump, fan, ignition parts, or a pressure sensor. Parts are extra to labour, and an older boiler can reach the point where repair money is better spent on replacement — a new boiler installation is notifiable work under the Building Regulations, and a Gas Safe engineer registers it and you should receive a Building Regulations compliance certificate. Keep it; you will need it when you sell.

Costs, from the ledger

A diagnostic visit plus a common repair in London is commonly £180 to £550 including parts for a typical component. A replacement boiler, supplied and fitted, is commonly £1,800 to £3,200 for a straightforward like-for-like swap. Full assumptions are on the costs guide.