Emergency 01 · Burst & leaking pipes
Burst and leaking pipes: stop the water, then stop the damage spreading.
A burst pipe is two problems. The first is the water still coming in, under mains pressure. The second is the water already out, finding ceilings, electrics and floorboards. Deal with them in that order.
The first ten minutes
- Turn off the internal stopcock — clockwise, firmly, by hand. Common places: under the kitchen sink, in a downstairs cloakroom, under the stairs, by the front door, behind a bath panel. The full hunt is on the stopcock guide.
- If water is near electrics, switch off the affected circuit at the consumer unit if you can do so safely and dry-handed. Never handle switches with wet hands or standing in water.
- Open the cold taps, lowest first, to drain the system and take the pressure off the burst. Flush toilets to empty cisterns.
- If you have a loft tank or a hot water cylinder, tie up the ball valve or turn off the gate valve on the feed — a tank can keep feeding a leak long after the stopcock is shut.
- Contain: towels, buckets, and move what water ruins fastest — documents, electrics, soft furnishings. Photograph the damage before you clear up, for insurance.
- Do not use sealant tapes or push-fit caps as a permanent repair on a pressurised main, and do not turn the water back on to test it until the repair is done.
Which pipe has gone?
Supply side (clean water, under pressure): sprays or runs constantly, and stops when the stopcock closes. Waste side: leaks only when a bath, basin or appliance empties. Heating circuit: often a slow drip at a radiator valve or under a floor, and the boiler pressure gauge falls. Each has a different repair and a different urgency. A waste leak you can stop simply by not using that fitting; a supply burst cannot wait.
Converted flats: the Ealing complication
In a converted Victorian house, your stopcock may control only your flat, or the whole building’s shared supply. If closing your valve does not stop the flow, the leak may be on a shared supply pipe or in the flat above. Shared supply pipes are jointly the responsibility of the properties they serve; Thames Water is responsible only for the communication pipe from the street main to the boundary. Tell the other household straight away — in a flat, the fastest leak repair is usually a neighbour answering the door.
What a repair is likely to cost
From the ledger on the costs guide: a make-safe visit plus a straightforward accessible repair in London is commonly £180 to £450 in total, including the call-out. Buried pipework, a repair under a tiled floor, or out-of-hours attendance moves it up. Ask for the price structure in writing before work starts.