Guide & connection service — not a plumbing firm, and it performs no plumbing workEaling, London W5 & W13No telephone number is published for this service — requests go through the form
Emergency Plumber Ealing
The Isolation Register — first isolate, then decide

Emergency 05 · Water pressure

No water, weak pressure, or pipes that bang: check the boundary before you pay anyone.

Pressure problems divide cleanly in two. Some belong to the network, and are Thames Water’s to fix at no cost to you. Some belong to the house. Ten minutes of checking tells you which.

The boundary checks

  1. Ask a neighbour. If the street has no water, it is a network event. Thames Water publishes incident information and has duties to restore supply and, for longer interruptions, to provide alternative water.
  2. Check your internal stopcock is fully open — a valve left half closed after earlier work is a common and free fix.
  3. Compare taps. Weak at every cold tap including the kitchen (which is usually fed straight from the main) suggests supply or stopcock. Weak only upstairs, or only on hot water, suggests the house system: a tank-fed layout, a scaled heat exchanger in a combi boiler, or a failing pump.
  4. Look for the leak. A sudden pressure drop in one property can be your own supply pipe leaking underground — check the meter and see the leak detection guide.

What the house side can be

Shared supply pipes: in converted Ealing flats, one supply serves several homes; pressure falls when everyone draws at once, and the long-term fix — separate or larger supplies — is a bigger, jointly organised job. Lead or old iron supply pipes narrow internally over decades. Limescale: London water is hard, and scale restricts plate heat exchangers, shower valves and tap cartridges; a shower that has weakened over a year is usually scale, not the network. Water hammer — the bang when a tap or appliance valve snaps shut — is cured by fixing the loose pipework, the faulty valve or fitting an arrester, in that order of cost.

Boosting pressure, within the rules

Pumps are regulated territory: the Water Supply (Water Fittings) Regulations 1999 limit how much water may be drawn directly from the main, and pumps above a modest rate must not be fitted directly to the mains — a break tank arrangement is used instead. A WaterSafe approved plumber will know the limit and design to it. Building Regulations Part G also bears on hot water safety, storage temperatures and scald protection in new or altered installations.

Costs, from the ledger

A diagnostic visit and a straightforward first fix — a stopcock freed or replaced, a scaled cartridge or a faulty valve — is commonly £90 to £240 in London. Supply pipe renewal and pump-and-tank work are quoted jobs, not emergency rates.