Emergency 04 · Leak detection
A leak you cannot see is still doing damage. Find it in the right order.
The signs are consistent: a water meter that turns when nothing is running, a boiler losing pressure, a damp patch that grows in dry weather, a musty smell under a floor, or a water bill that jumps. Leak detection is a sequence, not a single gadget.
The sequence a competent firm follows
- Prove there is a leak. Read the meter, use no water for an hour or two, read it again. On a heating system, note how fast pressure falls. This separates a leak from a dripping tap you already know about.
- Isolate by zone. Closing internal valves in turn — heating circuit, hot feed, cold feed, individual floors — narrows the leak to one part of the system without opening anything up.
- Listen. Acoustic listening equipment picks up the sound of escaping pressurised water through floors and walls. It works well on supply leaks and poorly on slow waste leaks, which is why it is not step one for everything.
- Trace. Tracer gas (a safe hydrogen and nitrogen mix) is introduced into an emptied pipe and detected where it escapes — useful under solid floors. Thermal imaging shows temperature differences that can indicate a leaking hot pipe, but it suggests rather than proves, and a good operative will say so.
- Confirm before opening up. One small, targeted opening to confirm, then the repair. Anyone proposing to lift a whole floor on a suspicion has skipped steps.
Supply pipe leaks and Thames Water
If the leak is on your underground supply pipe, between the boundary and the house, it is yours to repair — and in older Ealing homes that pipe may be lead. Thames Water operates a lead supply pipe replacement approach under which, if you replace your lead supply pipe, it replaces its lead communication pipe. Use a WaterSafe approved plumber for supply pipe work: their work can be self-certified under the Water Supply (Water Fittings) Regulations 1999, which can save a Thames Water inspection. Ask about this before the trench is dug, not after.
Costs, from the ledger
A leak detection visit in London is commonly £250 to £595, depending on the methods needed, with the repair itself extra unless a fixed price was agreed in writing beforehand. Trace-and-access cover on a home insurance policy sometimes pays for the finding work — check the policy before you book, and keep the report either way.